K K Geo System | 3D Scanning & Metrology Solutions IndiaPrecision 3D Laser Scanning & Dimensional Metrology Solutions
K K Geo System | 3D Scanning & Metrology Solutions IndiaMetallurgy / Metzer / Weld Penetration Analysis Systems
METZER / METALLURGY
Measure prepared weld cross-sections and document the results with imaging and weld analysis software.
Enquire About This Range
Microscope hardware for weld-section imaging
Metzer weld penetration analysis combines a prepared weld section, compatible imaging hardware and Weld Check Pro software. The workflow captures the weld profile and supports dimensional evaluation, annotation and reporting. It is suited to section-based inspection where the joint geometry and penetration must be recorded against a defined procedure.
Use the system for prepared weld cross-section examination, profile measurements and illustrated inspection records. The required measurements are set by your inspection procedure.
THE METZER RANGE
Compare the specification highlights and choose a model to discuss with our team.
Software for prepared weld cross-sections.
Measurement
Linear dimensions / weld profile
Analysis
Weld percentage / defect highlighting
Documentation
Annotation and report generation
Weld Check Pro combines with a suitable microscope, camera and specimen preparation equipment. Ask our team to specify the complete configuration.
Answers to common questions about weld penetration analysis systems.
Is weld cross-section analysis non-destructive?
No. Preparing a cross-section normally involves cutting through a sample or test piece. This page covers section-based imaging and measurement, not non-destructive examination of an intact weld.
Does the software automatically certify weld quality?
No. Measurements and annotations support evaluation. Acceptance depends on the inspection procedure, specified limits and the judgement of the responsible inspector.
What can be measured?
Suitable images can support linear dimensions and weld profile evaluation using the selected software tools. Define the required dimensions and reporting method before selecting the system.
What is needed for a quotation?
Provide the weld process, joint type, section dimensions, required measurements and an example report. Include details of any imaging hardware already in use.
Send a prepared-section image or drawing and your inspection requirements to K K Geo System for a Metzer imaging and analysis quotation.
Request a Quotation