K K Geo System | 3D Scanning & Metrology Solutions IndiaPrecision 3D Laser Scanning & Dimensional Metrology Solutions
K K Geo System | 3D Scanning & Metrology Solutions IndiaMetallurgy / Metzer / Micro-Vickers Hardness Testers
METZER / METALLURGY
Evaluate hardness in small regions of prepared specimens with manual, automatic-turret and automated measurement options.
Enquire About This Range
Metzer · Micro-Vickers Hardness Testers
Metzer Micro-Vickers hardness testers combine controlled indentation with optical measurement of the impression. They support testing where the location of each indentation matters, allowing a prepared section to be evaluated at selected points. The test force, specimen preparation and spacing of impressions must suit the material feature and test method.
Micro-Vickers testing is useful for localised hardness evaluation and sequences of measurements across a prepared section, where specimen dimensions and the required method permit.
THE METZER RANGE
Compare the specification highlights and choose a model to discuss with our team.
Manual turret with keypad display.
Test forces
10 gf–1 kgf
Turret
Manual
Specimen clearance
110 mm height / 110 mm throat
Metzer catalogue p. 15
Enquire about this model →Automatic turret with touch screen.
Test forces
10 gf–1 kgf
Display
5.6-inch touch screen
Specimen clearance
110 mm height / 110 mm throat
Metzer catalogue p. 15
Enquire about this model →Automated positioning and measurement.
Test forces
10 gf–1 kgf
Automation
Motorized XY / autofocus
Specimen clearance
160 mm height / 160 mm throat
Metzer catalogue p. 14
Enquire about this model →Specification highlights are based on Metzer product literature. The quotation defines the selected model, accessories and supplied configuration.
Answers to common questions about micro-vickers hardness testers.
What does a Micro-Vickers tester measure?
It determines hardness from an indentation made under a selected force and measured optically. The force and impression dimensions are used in the hardness calculation.
Is an automatic turret a fully automated tester?
No. An automatic turret changes between indenter and objectives. Automated positioning, focusing, impression measurement and reporting are separate capabilities.
Why is surface preparation important?
The impression edges must be visible for optical measurement. Surface condition and preparation can influence whether a small impression can be measured reliably.
What information is needed to choose a tester?
Specify the material, specimen thickness, required test forces, indentation pattern and reporting needs. Include the expected number of tests and desired automation.
Share your specimen details and test sequence with K K Geo System to discuss Metzer tester, stage and software options.
Request a Quotation